Start by cutting a little bit of the film in one corner. Next, use the knife to make a tab, so it’s easy to peel. Then, gently peel the tint while holding onto the tab you created. Continue the same process until you get rid of most of the tint. Then, spray some soapy water and use the knife to remove the glue left behind.

Posts: 47. Clear Protective Film. Wifey and I have been discussing lately how hideous the rock guard film (Durashield) on the front of our Journey has become and are curious what options we have when replacing. We are getting a quote to remove the film and buff and spray on the Optimum Opti- Coat. Any ideas are appreciated.
If you are unsure whether there is masking film on the sheet, scratch the surface lightly with a fingernail. Light scratches will be clearly visible on the film but will not damage the sheet. Take care not to damage the PLEXIGLAS® with sharp objects. If the stored sheets are exposed to weathering, the film must be removed within four weeks.
Removing old clear bra paint protection film off a car sucks but it is possible. Full video on how to do it here on the @HazardGarage channel:
1. Acetone! I had the exact same problem - I tried hot water, scraping, soaking, and nothing worked. Then I saw a post in a different forum suggesting nail polish remover, and voila! The film peeled right off! 20 Jan 2018 at 11:33. #12. 14 years ago. I agree, eventually with bad smell/pollution, it will burn off, but if it's not totally baked on, a solvent like wd-40 or diesel will remove adhesive, but you must of course clean it thoroughly so no traces remain before you fire it up. I can almost guarantee it's stainless steel which commonly does come with a protective plastic Po3C.
  • amc793xkw9.pages.dev/128
  • amc793xkw9.pages.dev/431
  • amc793xkw9.pages.dev/79
  • amc793xkw9.pages.dev/410
  • amc793xkw9.pages.dev/117
  • amc793xkw9.pages.dev/79
  • amc793xkw9.pages.dev/428
  • amc793xkw9.pages.dev/61

    • how to remove old protective film